SIMULATION STUDY OF HYDRODYNAMIC CAVITATION IN THE ORIFICE FLOW
Konrad PIETRYKOWSKI
wm.ktmp@pollub.plLublin University of Technology, Faculty of Mechanical Engineering, Department of Thermodynamics, Fluid Mechanics, and Aircraft Propulsion System, Lublin (Poland)
Paweł KARPIŃSKI
Lublin University of Technology, Faculty of Mechanical Engineering, Department of Thermodynamics, Fluid Mechanics, and Aircraft Propulsion Systems, Lublin, (Poland)
Abstract
Hydrodynamic cavitation is a phenomenon that can be used in the water treatment process. For this purpose, venturis or orifices varying in geometry are used. Studying this phenomenon under experimental conditions is challenging due to its high dynamics and difficulties in measuring and observing the phase transition of the liquid. For this reason, the CFD method was used to study the phenomenon of hydrodynamic cavitation occurring in water flow through the orifice and then analyze flow parameters for different boundary conditions. The research was performed for four different orifice geometries and two defined fluid pressure values at the inlet, based on a computational 2D model of the research object created in Ansys Fluent software. As a result of the numerical simulation, the distribution of fluid velocity and pressure and volume fraction of the gas phase were obtained. A qualitative and quantitative analysis of the phenomenon of hydrodynamic cavitation under the considered flow conditions was conducted for the defined orifice geometries. The largest cavitation zone and thus the largest volume fraction of the gas phase was obtained for the orifice diameter of 2 mm with a sharp increase in diameter. However, the geometry with a linear change in diameter provided the largest volume fraction of the gas phase per power unit.
Keywords:
cavitation, CFD, fluid flow, hydrodynamics, orifice, simulationReferences
Brennen, C. E. (2011). Hydrodynamics of pumps. Cambridge University Press.
DOI: https://doi.org/10.1017/CBO9780511976728
Google Scholar
Capocelli, M., Musmarra, D., Prisciandaro, M., & Lancia, A. (2014). Chemical effect of hydrodynamic cavitation: simulation and experimental comparison. AIChE Journal, 60(7), 2566–2572. https://doi.org/10.1002/aic.14472
DOI: https://doi.org/10.1002/aic.14472
Google Scholar
Ding, H., Visser, F. C., Jiang, Y., & Furmanczyk, M. (2011). Demonstration and validation of a 3D CFD simulation tool predicting pump performance and cavitation for industrial applications. Journal of fluids engineering, 133(1), 011101. https://doi.org/10.1115/1.4003196
DOI: https://doi.org/10.1115/1.4003196
Google Scholar
Franc, J. P. (2006). Physics and control of cavitation. Grenoble Univ (France).
Google Scholar
Gągol, M., Przyjazny, A., & Boczkaj, G. (2018). Wastewater treatment by means of advanced oxidation processes based on cavitation–a review. Chemical Engineering Journal, 338, 599–627. https://doi.org/10.1016/j.cej.2018.01.049
DOI: https://doi.org/10.1016/j.cej.2018.01.049
Google Scholar
Gogate, P. R., & Pandit, A. B. (2000). Engineering design methods for cavitation reactors II: hydrodynamic cavitation. AIChE Journal, 46(8), 1641–1649. https://doi.org/10.1002/aic.690460815
DOI: https://doi.org/10.1002/aic.690460815
Google Scholar
Gogate, P. R., Tayal, R. K., & Pandit, A. B. (2006). Cavitation: a technology on the horizon. Current science, 91(1), 35–46.
Google Scholar
Gogate, P. R., Thanekar, P. D., & Oke, A. P. (2020). Strategies to improve biological oxidation of real wastewater using cavitation based pre-treatment approaches. Ultrasonics Sonochemistry, 64, 105016. https://doi.org/10.1016/j.ultsonch.2020.105016
DOI: https://doi.org/10.1016/j.ultsonch.2020.105016
Google Scholar
Iannetti, A., Stickland, M. T., & Dempster, W. M. (2016). A CFD and experimental study on cavitation in positive displacement pumps: Benefits and drawbacks of the ‘full’cavitation model. Engineering Applications of Computational Fluid Mechanics, 10(1), 57–71. https://doi.org/10.1080/19942060.2015.1110535
DOI: https://doi.org/10.1080/19942060.2015.1110535
Google Scholar
Kunz, R. F., Boger, D. A., Chyczewski, T. S., Stinebring, D., Gibeling, H., & Govindan, T. (1999). Multi-phase CFD analysis of natural and ventilated cavitation about submerged bodies. In Proceedings of the 3rd ASME-JSME Joint Fluids Engineering Conference. American Society of Mechanical Engineers.
Google Scholar
Menter, F. (1993). Zonal two equation kw turbulence models for aerodynamic flows. In 23rd fluid dynamics, plasmadynamics, and lasers conference (p. 2906).
DOI: https://doi.org/10.2514/6.1993-2906
Google Scholar
Menter, F. R. (1994). Two-equation eddy-viscosity turbulence models for engineering applications. AIAA journal, 32(8), 1598–1605.
DOI: https://doi.org/10.2514/3.12149
Google Scholar
Moholkar, V. S., & Pandit, A. B. (1997). Bubble behavior in hydrodynamic cavitation: effect of turbulence. AIChE Journal, 43(6), 1641–1648.
DOI: https://doi.org/10.1002/aic.690430628
Google Scholar
Omelyanyuk, M., Ukolov, A., Pakhlyan, I., Bukharin, N., & El Hassan, M. (2022). Experimental and Numerical Study of Cavitation Number Limitations for Hydrodynamic Cavitation Inception Prediction. Fluids, 7(6), 198. https://doi.org/10.3390/fluids7060198
DOI: https://doi.org/10.3390/fluids7060198
Google Scholar
Patil, P. B., Bhandari, V. M., & Ranade, V. V. (2021). Improving efficiency for removal of ammoniacal nitrogen from wastewaters using hydrodynamic cavitation. Ultrasonics Sonochemistry, 70, 105306. https://doi.org/10.1016/j.ultsonch.2020.105306
DOI: https://doi.org/10.1016/j.ultsonch.2020.105306
Google Scholar
Salvatore, F., Streckwall, H., & Van Terwisga, T. (2009). Propeller cavitation modelling by CFD-results from the VIRTUE 2008 Rome workshop. In Proceedings of the first international symposium on marine propulsors, Trondheim, Norway (pp. 22–24).
Google Scholar
Sauer, J., & Schnerr, G. H. (2001). Development of a new cavitation model based on bubble dynamics. ZAMM‐Journal of Applied Mathematics and Mechanics/Zeitschrift für Angewandte Mathematik und Mechanik, 81(S3 S3), 561–562. https://doi.org/10.1002/zamm.20010811559
DOI: https://doi.org/10.1002/zamm.20010811559
Google Scholar
Schnerr, G. H., & Sauer, J. (2001). Physical and numerical modeling of unsteady cavitation dynamics. In Fourth international conference on multi-phase flow (Vol. 1). ICMF New Orleans.
Google Scholar
Shi, H., Li, M., Nikrityuk, P., & Liu, Q. (2019). Experimental and numerical study of cavitation flows in venturi tubes: From CFD to an empirical model. Chemical Engineering Science, 207, 672–687.
DOI: https://doi.org/10.1016/j.ces.2019.07.004
Google Scholar
Singhal, A. K., Athavale, M. M., Li, H., & Jiang, Y. (2002). Mathematical basis and validation of the full cavitation model. J. Fluids Eng., 124(3), 617–624. https://doi.org/10.1115/1.1486223
DOI: https://doi.org/10.1115/1.1486223
Google Scholar
Subhas, S., Saji, V. F., Ramakrishna, S., & Das, H. N. (2012). CFD analysis of a propeller flow and cavitation. International Journal of Computer Applications, 55(16), 26–33.
DOI: https://doi.org/10.5120/8841-3125
Google Scholar
Tao, Y., Cai, J., Huai, X., Liu, B., & Guo, Z. (2016). Application of hydrodynamic cavitation to wastewater treatment. Chemical engineering & technology, 39(8), 1363–1376. https://doi.org/10.1002/ceat.201500362
DOI: https://doi.org/10.1002/ceat.201500362
Google Scholar
Wang, B., Su, H., & Zhang, B. (2021). Hydrodynamic cavitation as a promising route for wastewater treatment– A review. Chemical Engineering Journal, 412, 128685. https://doi.org/10.1016/j.cej.2021.128685
DOI: https://doi.org/10.1016/j.cej.2021.128685
Google Scholar
Zheng, X. B., Liu, L. L., Guo, P. C., Hong, F., & Luo, X. Q. (2018, July). Improved Schnerr-Sauer cavitation model for unsteady cavitating flow on NACA66. IOP Conference Series: Earth and Environmental Science, 163(1), 012020).
DOI: https://doi.org/10.1088/1755-1315/163/1/012020
Google Scholar
Zwart, P. J., Gerber, A. G., & Belamri, T. (2004, May). A two-phase flow model for predicting cavitation dynamics. In Fifth international conference on multi-phase flow, Yokohama, Japan ( No. 152).
Google Scholar
Authors
Konrad PIETRYKOWSKIwm.ktmp@pollub.pl
Lublin University of Technology, Faculty of Mechanical Engineering, Department of Thermodynamics, Fluid Mechanics, and Aircraft Propulsion System, Lublin Poland
Authors
Paweł KARPIŃSKILublin University of Technology, Faculty of Mechanical Engineering, Department of Thermodynamics, Fluid Mechanics, and Aircraft Propulsion Systems, Lublin, Poland
Statistics
Abstract views: 313PDF downloads: 219
License
All articles published in Applied Computer Science are open-access and distributed under the terms of the Creative Commons Attribution 4.0 International License.
Most read articles by the same author(s)
- Zbigniew CZYŻ, Paweł KARPIŃSKI, Krzysztof SKIBA, Szymon BARTKOWSKI, NUMERICAL CALCULATIONS OF WATER DROP USING A FIREFIGHTING AIRCRAFT , Applied Computer Science: Vol. 19 No. 3 (2023)
- Zbigniew CZYŻ, Paweł KARPIŃSKI, Tacetdin SEVDIM, NUMERICAL ANALYSIS OF THE DRAG COEFFICIENT OF A MOTORCYCLE HELMET , Applied Computer Science: Vol. 14 No. 1 (2018)
- Konrad PIETRYKOWSKI, Tytus TULWIN, THE NONUNIFORMITY OF THE PISTON MOTION OF THE RADIAL ENGINE , Applied Computer Science: Vol. 13 No. 2 (2017)
- Paweł KARPIŃSKI, THE INFLUENCE OF THE INJECTION TIMING ON THE PERFORMANCE OF TWO-STROKE OPPOSED-PISTON DIESEL ENGINE , Applied Computer Science: Vol. 14 No. 2 (2018)
Similar Articles
- Tytus TULWIN, MODELLING OF A LARGE ROTARY HEAT EXCHANGER , Applied Computer Science: Vol. 13 No. 1 (2017)
- Tomasz SEDERYN, Małgorzata SKAWIŃSKA, COMPUTATIONAL ANALYSIS OF PEM FUEL CELL UNDER DIFFERENT OPERATING CONDITIONS , Applied Computer Science: Vol. 19 No. 4 (2023)
- Sławomir KUKLA, Marek SMETANA, A SIMULATION EXPERIMENT AND MULTI-CRITERIA ASSESSMENT OF MANUFACTURING PROCESS FLOW VARIANTS TESTED ON A COMPUTER MODEL , Applied Computer Science: Vol. 13 No. 2 (2017)
- Arkadiusz GOLA, Łukasz WIECHETEK, MODELLING AND SIMULATION OF PRODUCTION FLOW IN JOB-SHOP PRODUCTION SYSTEM WITH ENTERPRISE DYNAMICS SOFTWARE , Applied Computer Science: Vol. 13 No. 4 (2017)
- Rafał KLIZA, Karol ŚCISŁOWSKI, Ksenia SIADKOWSKA, Jacek PADYJASEK, Mirosław WENDEKER, STRENGTH ANALYSIS OF A PROTOTYPE COMPOSITE HELICOPTER ROTOR BLADE SPAR , Applied Computer Science: Vol. 18 No. 1 (2022)
- Wojciech DANILCZUK, THE USE OF SIMULATION ENVIRONMENT FOR SOLVING THE ASSEMBLY LINE BALANCING PROBLEM , Applied Computer Science: Vol. 14 No. 1 (2018)
- Jarosław GIL, Andrzej POLAŃSKI, APPLICATION OF GILLESPIE ALGORITHM FOR SIMULATING EVOLUTION OF FITNESS OF MICROBIAL POPULATION , Applied Computer Science: Vol. 18 No. 4 (2022)
- Paweł MAGRYTA, AERODYNAMIC RESEARCH OF THE OVERPRESSURE DEVICE FOR INDIVIDUAL TRANSPORT , Applied Computer Science: Vol. 13 No. 1 (2017)
- Grzegorz SUCHANEK, Roman FILIPEK, COMPUTATIONAL FLUID DYNAMICS (CFD) AIDED DESIGN OF A MULTI-ROTOR FLYING ROBOT FOR LOCATING SOURCES OF PARTICULATE MATTER POLLUTION , Applied Computer Science: Vol. 18 No. 3 (2022)
- Sebastian BIAŁASZ, Ramon PAMIES, NUMERICAL SIMULATION OF THE DESIGN OF EXTRUSION PROCESS OF POLYMERIC MINI-TUBES , Applied Computer Science: Vol. 14 No. 3 (2018)
You may also start an advanced similarity search for this article.