The influence of steel yielding of main reinforcement on bending capacity of beams strengthened with CFRP strips

Przemysław Bodzak


Department of Concrete Structures; Faculty Civil Engineering; Architecture and Environmental Engineering; Lodz University of Technology (Poland)

Abstract

This paper describe tests on RC beams strengthened with externally bounded CFRP plates. A total of four PCC beams with rectangular 15×30cm cross section and 300cm clear span were manufactured and tested in four-point flexure with 100cm constant moment region. Low compressive strength of concrete fck about 20MPa and middle reinforcement ratio – 0,0075 were used. Different yield strengths of steel, from 360MPa to 1860MPa, were chosen as experimental variables. All the beams were strengthened with one CFRP strip measuring 5×1,2cm. The specimen failed at various load and at various ultimate strains of CFRP strips. It was generally observed that both the moment capacity and the ultimate strains grew with the increase of steel yielding strength. It could be deducted that in many cases reaching the yielding steel strength activates the deboning of FRP strips.


Keywords:

RC beam, strengthening, CFRP strips, steel yielding

Hashemi S.H., Rahgozar R., Maghsoudi A.A. Flexural testing of high strength reinforced concrete beams strengthened with CFRP sheets. IJE Transactions B: Applications, Vol. 22, No. 2, August 2009.
  Google Scholar

Sayed-Ahmed E.Y., Bakay R., Shrive N.G. Bond strength of FRP laminates to Concrete: State of the art review. Electronic Journal of Structural Engineering, 9 (2009).
DOI: https://doi.org/10.56748/ejse.9117   Google Scholar

Wu Z., Niu H. Prediction of crack-induced debonding failure in R/C structures flexurally strengthened with externally bonded FRP composites. Doboku Gakkai Ronbunshuu E, Vol. 63, No.4, 2007.12, p. 620-639.
DOI: https://doi.org/10.2208/jsceje.63.620   Google Scholar

Foster S.J., Khomwan N. Determination of bond stress versus slip for externally bonded FRP from standardized bond strength tests. Proceedings of the International Symposium on Bond Behaviour of FRP in Structures (BBFS 2005)
  Google Scholar

Karta techniczna Taśmy Sika CarboDur. Taśmy z włókien węglowych do wzmocnień konstrukcji.
  Google Scholar


Published
2013-03-11

Cited by

Bodzak, P. (2013) “The influence of steel yielding of main reinforcement on bending capacity of beams strengthened with CFRP strips”, Budownictwo i Architektura, 12(1), pp. 085–090. doi: 10.35784/bud-arch.2177.

Authors

Przemysław Bodzak 

Department of Concrete Structures; Faculty Civil Engineering; Architecture and Environmental Engineering; Lodz University of Technology Poland

Statistics

Abstract views: 182
PDF downloads: 101


License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Budownictwo i Architektura supports the open science program. The journal enables Open Access to their publications. Everyone can view, download and forward articles, provided that the terms of the license are respected.

Publishing of articles is possible after submitting a signed statement on the transfer of a license to the Journal.